IOT wants to say HAPPY HALLOWEENWe found a little treat for you, get your pumpkins ready!!
You Will Need:
A craft knife (one where you can easily snap off the blade to get a new sharp one is ideal).
A cutting board or piece of card on which to cut the stencil.
A piece of acetate or stiff plastic, see-through is easiest.
A printout of the stencil design (you can enlarge or reduce this on a photocopier).
Some tape (ideally repositional or low-tack so your stencil doesn't get sticky).
You Will Need:
A craft knife (one where you can easily snap off the blade to get a new sharp one is ideal).
A cutting board or piece of card on which to cut the stencil.
A piece of acetate or stiff plastic, see-through is easiest.
A printout of the stencil design (you can enlarge or reduce this on a photocopier).
Some tape (ideally repositional or low-tack so your stencil doesn't get sticky).
Preparation for Cutting a Stencil
Use a few pieces of tape to secure the printout of the stencil design to the piece of acetate along the edges so that it doesn't slip when you start cutting the stencil. Position the design so there is a border of acetate at least an inch (2.5cm) around the whole design.
